Issue: Power Source
- Verify that the treadmill is plugged directly into the wall, not into an extension cord, surge protector or power strip.
- Verify that the treadmill has the correct amp circuit requirements.
- Verify circuit is not sharing power with appliances, computers, TVs etc. The treadmill should be plugged into a circuit by itself, sharing circuits can cause a failure of the electronic components.
Issue: Console Wiring
- Unplug treadmill from wall outlet, wait 60 seconds allowing lower board to discharge built up energy, remove screws that hold the console electronics to the console housing, gently lift the console faceplate and electronics from the console housing. Check that the console cable (refer to manual if needed) is securely attached to the console circuit board, reattach cable securely is needed.
- Locate the male/female connection between the console and mast, make sure the connection is secure, reattach cable if needed.
- Remove motor cover, verify that there are no lights lit on the lower circuit board. Check that the console wiring is securely connected to the circuit board. reattached securely if needed.
- Plug treadmill in and check status.